Machine & computer cannot connect
Machine & computer cannot connectConnecting for the first time, please confirm as follows:
1. Is the "UAC Settings" selected as lowest or never notified?
2. Is the CNC control system installed normally and successfully? And did it pop up the warning window?
3. Does the power cord connect normally?
4. Does the USB cable connect normally? Does changing the other USB ports on the computer solve the issue?
5. Did the power go off because the emergency switch was pressed?
6. Re-open the Bravoprodigy CNC control system
If you are not connecting for the first time, please confirm as follows:
1. Can the sleep (hibernate) mode be turned off in the computer operating system?
2. Is the version of the CNC control system correct?
3. Does the power cord connect normally?
4. Does the USB cable connect normally? Is the USB port deformed or loose after being pulled?
5. Is the power on?
6. Did the power off because the emergency switch was pressed?
7. Has the fuse been blown
8. Do you hear the sound of the motor overcharging after turning on the power?