Machine & computer cannot connect

Connecting in the first time, please confirm as follows:
  1. Is the "UAC Settings" selected as lowest or never notified?
  2. Is the CNC control system installed normally and successfully? And did it pop up the warning window?
  3. Does the power cord connect normally?
  4. Does the USB cable connect normally? Is changing the other USB ports on the computer and the issue solved?
  5. Did the power off because the emergency switch was pressed?
  6. Re-open the Bravoprodigy CNC control system

If you are not connecting for the first time, please confirm as follows:
  1. Have the sleep (hibernate) mode in the computer operating system be turned off?
  2. If the version of the CNC control system is correct?
  3. Does the power cord connect normally?
  4. Does the USB cable connect normally? Is the USB port deformed or loose due to pulling?
  5. Does the power on?
  6. Did the power off because the emergency switch was pressed?
  7. Has the fuse been blown?
  8. Do you hear the sound of the motor overcharging after turning on the power?
Back
Top